CyberAtom X-200 User Manual
X-200 Product Page
About
Block Diagram
Axes Conventions
System Startup
Selecting Power Source
Hardware Reset
Booting Stages
LED indicator
Getting Output Data
Orientation
Data-Ready Signal
Sensor Measurement Data
Settings
Calibration
Accelerometer Sensor
Magnetometer Sensor
Gyroscope Sensor
Tuning
Trusting Accelerometer Measurements
Trusting Magnetometer Measurements
I2C Interface
Request-Only Transaction
Request-Response Transaction
Request-Only Messages
Request-Response Messages
UART Interface
Transmission Parameters
Message Format
Request Messages
Response Messages
USB Interface
USB Message Format
Request Messages
Response Messages
Troubleshooting
Factory Defaults
Configuring UDEV system on Linux Systems for CyberAtom Devices
Installing USB Driver for CyberAtom Devices on Windows
Identify CyberAtom Device Using USB Connection
Firmware Upgrade Using USB Interface
Firmware Upgrade Using UART Interface
Recovering Device Firmware
Legal Notice
UART Interface
Figure 1.
Example schematics of CyberAtom as an UART controlled device.
Transmission Parameters
Message Format
Request Messages
Response Messages
