Only RevB of the X-200 boards have JP1 jumper that enables this procedure.
If you are about to perform this operation on non-RevB board version, please contact and ask for technical support.
If at any point the firmware is corrupted, it is possible to boot
device to bootloader mode and repeat device firmware installation procdure.
-
Power OFF the device.
-
Join (e.g. solder) JP1 jumper on the device board.
-
Power ON the device.
The device will boot to the bootloader mode. At this point, cyber-boot tool can be used to flash the firmware.
When done, JP1 jumper should be disconnected.
