CyberAtom X-202 User Manual
X-202 Product Page
About
Block Diagram
Axes Conventions
System Startup
Hardware Reset
LED indicator
Getting Output Data
Orientation
Data-Ready Signal
Sensor Measurement Data
Settings
Calibration
Accelerometer Sensor
Magnetometer Sensor
Gyroscope Sensor
Tuning
Trusting Accelerometer Measurements
Trusting Magnetometer Measurements
I2C Interface
Request-Only Transaction
Request-Response Transaction
Request-Only Messages
Request-Response Messages
UART Interface
Transmission Parameters
Message Format
Request Messages
Response Messages
Troubleshooting
Factory Defaults
Firmware Upgrade Using UART Interface
Recovering Device Firmware
Legal Notice
LED indicator
When powered on, the LED indicator blinks with approximately 1 Hz frequency.
